The main points of maintenance and maintenance of high pressure and low pressure equipment

The maintenance of high-voltage and low-voltage equipment is an important link to ensure the long-term stable operation of the equipment. Whether it is high-pressure equipment or low-pressure equipment, reasonable maintenance can effectively extend the service life of the equipment, improve the working efficiency of the equipment, and reduce the occurrence of equipment failure. This article will introduce you to the main points of maintenance and maintenance of high pressure and low pressure equipment.

1. regular cleaning of equipment

Dust and impurities are easy to accumulate on the surface and inside of high-pressure and low-pressure equipment, and long-term accumulation will have a negative impact on the thermal conductivity and working efficiency of the equipment. Therefore, regular cleaning of equipment is one of the important measures to keep the equipment working properly. Cleaning equipment shall comply with the following requirements:

1. Use a clean and soft cloth to wipe the surface of the equipment, avoid using hard objects to scratch the equipment: to prevent scratches on the surface of the equipment or damage to key parts of the equipment.

2. Use special equipment or tools to clean the inside of the equipment, and operate carefully to avoid damage to the equipment.

3. Pay attention to the power failure when cleaning the equipment, and follow the relevant safety regulations to ensure their own safety.

2. check the electrical connections

When maintaining high-voltage and low-voltage equipment, the stability and reliability of electrical connections should be checked regularly. Poor electrical connection may cause equipment short circuit, leakage and other problems, thereby affecting the normal operation of the equipment. The following are the main points to check the electrical connections:

1. Check whether the power cord, plug and cable are obviously damaged. If there is any damage, replace it in time.

2. Measure the contact resistance of the electrical connection to ensure that the connection is firm.

3. Check the normal working state of electrical components. If abnormal conditions are found, repair or replace them in time.

3. regular lubrication equipment

The normal operation of high-pressure and low-pressure equipment requires good lubrication conditions. Regular lubrication of equipment can effectively reduce equipment wear and friction, improve equipment efficiency, and extend equipment life. During equipment lubrication, the following points should be noted:

1. Determine the lubrication point and lubrication cycle, and lubricate according to the equipment manual or manufacturer's recommendations.

2. Select the appropriate lubricant and use the appropriate lubrication method to avoid excessive or insufficient lubrication.

3. Clean the lubrication area to ensure that no impurities enter and avoid contaminating the lubricant.

4. regular inspection and maintenance

Regular inspection is an important part of the maintenance and maintenance of high-voltage and low-voltage equipment. Through inspection, hidden problems of equipment can be found in time and repaired or replaced. The following are the main points of inspection and maintenance:

1. Check whether the outside of the equipment is damaged, deformed or falling off. If so, repair it in time.

2. Check the working condition of the equipment, such as abnormal noise, high temperature, etc., and conduct troubleshooting and repair in time.

3. Check whether the connecting screws and fasteners of the equipment are loose, if any, they should be tightened.

In summary, the main points of maintenance and maintenance of high-voltage and low-voltage equipment include regular cleaning of equipment, inspection of electrical connections, regular lubrication of equipment, and regular inspections. Through reasonable maintenance measures, the normal operation of the equipment can be ensured, the service life of the equipment can be prolonged, and the working efficiency of the equipment can be improved. I hope this article is helpful to you.